Oiled oak is meant to be looked after, not left alone. A fresh coat once or twice a year keeps the surface water-resistant and gives it that low, even sheen. The whole job takes less than an hour.
When it's time#
Drip a little water on the busiest part of the table. If it beads up, the oil is still doing its job. If it soaks in and leaves a dark spot within a minute, it's time to re-oil.
Step 1: Clean the surface#
Wipe the table with a cloth wrung out in warm water and a drop of mild soap. Let it dry completely, at least an hour. Oil won't bond to a damp or greasy surface.
Step 2: Lightly sand any rough patches#
Use a fine 240-grit pad, always moving with the grain. You're not removing the old finish, just smoothing raised fibres and small marks. Wipe away the dust with a dry cloth.
Step 3: Apply a thin coat#
Pour a small amount of oil onto a cotton cloth, not straight onto the wood. Work it in along the grain in sections, using firm, even pressure. Thin is better: a thick coat stays tacky and attracts dust.
Step 4: Wipe off the excess#
After 10 to 15 minutes, take a clean cloth and buff off anything still sitting on the surface. The wood should feel smooth and almost dry to the touch.
Step 5: Let it cure#
Leave the table overnight before using it, and avoid hot dishes and wet glasses for a few days while the oil hardens.




